70 A-96.250.341 / 061015
AMI Powercon
Program List and Explanations
9. Program List and Explanations
1 Messages
1.1 Pending Errors
1.1.5 Provides the list of active errors with their status (active, acknowl-
edged). If an active error is acknowledged, the alarm relay is active
again. Cleared errors are moved to the Message list.
1.2 Message List
1.2.1 Shows the error history: Error code, date / time of issue and status
(active, acknowledged, cleared). 65 errors are memorized. Then
the oldest error is cleared to save the newest error (circular buffer).
2 Diagnostics
In diagnostics mode, the values can only be viewed, not modified.
2.1 Identification
Desig.: Designation of the instrument.
Version: Firmware of instrument (e.g. V5.30-0912)
2.1.4 Factory Test: Test date of the Instrument, Motherboard and Fron-
tend
2.1.5 Operating Time: Years / Days / Hours / Minutes / Seconds
2.2 Sensors
2.2.1 Cond. Sensor
Current value in µS
Raw value in µS
Cell Constant
2.2.1.4 QA History: Review the QA values (Number, Date-Time, Deviation
Conductivity, Deviation Temperature) of the last quality assurance
procedures. Only for diagnostic purpose. Max. 65 data records are
memorized.
2.2.1.5 Cal. History: Review diagnostic values of the last calibrations.Only
for diagnostic purpose.
Number; Date, Time
Cell constant
Max. 64 data records are memorized. One process calibration
corresponds to one data record.
To Next Page
Loading...