Sylvac Hi Cal User Manual

25
LIn
E
SET
Clear
REF
I / II
Quit
Setup
MIN
MAX
DEL
SET
Clear
REF
I / II
Quit
Setup
MIN
MAX
DEL
SET
Clear
REF
I / II
Quit
Setup
MIN
MAX
DEL
Standard delivery
In the event of problems
It is possible to make a complete shutdown (equivalent to removing the
power supply) by pressing >5s on the ON button.
The ON button must then be pressed for >0.5s to restart the instrument.
Hi_Cal V2 150 mm Réf. N° : 830.0156
Hi_Cal V2 300 mm Réf N° : 830.0306
Hi_Cal V2 450 mm Réf N° : 830.0456
Including:
• 1 xed probe, with saphire ball 3 mm
• 1 master gauge
• 1 charger 9 V | 1660mA (mains AC voltage according to the country)
• 1 protection cover
• 1 calibration certicat
• 1 instruction manuel
• Other accessories: see the site www.sylvac.ch
Re-initialising the instrument
The initial instrument settings can be restored at any time by a prolonged
press (>4 sec) simultaneously on and until the message rESEt is
displayed.
Menu Settings
Access:
- Switch on the instrument by pressing ON + SETUP
- Wait for the «init» display and then navigate using the keys .
Lin correction +/-999 μm/m

Sylvac Hi Cal Specifications

General

Brand	Sylvac
Model	Hi Cal
Category	Measuring Instruments
Language	English