Synrad Firestar TI Series User Manual

getting started
15
Synrad Firestar ti-Series operator’s manual
Inventory
Contents description
Each item listed in Table 1-1 is described below.
SYNRAD Firestar ti-Series Laser – for cutting, welding, drilling, and marking a wide variety of products
and materials.
Firestar ti-Series Operator’s Manual – provides setup, operation, and maintenance information for your
Firestar ti-Series laser.
Quick Start Plug (except SA models) – connects to Firestar’s User I/O connector. Jumpers are built into
the plug to enable Firestar’s shutter and remote interlock circuits for initial start-up and testing.
Cooling Tubing (water-cooled only) – carries cooling water from the chiller to the laser and back. This
black polyethylene tubing is 1/2-inch O.D. by 30 feet and must be cut to length.
Mounting Bolts – 1/4–20 × 5/8" UNC bolts fasten Firestar to your mounting surface.
Spare Fuse – fast-acting mini ATO-type fuse protects Firestar’s internal circuitry.
Final Test Report (not shown) – contains data collected during the laser’s final pre-shipment test.

Synrad Firestar TI Series Specifications

General

Brand	Synrad
Model	Firestar TI Series
Category	Medical Equipment
Language	English