SystemAir DANVENT DV10 - 3 Dimensions of the Units; D.4 about Operation and Control; 5 Warnings about Dangers; Drawings, Diagrams, Guides and Instructions for the Use, Maintenance and Repair


18

d.3Dimensionsoftheunits
Seeannex2withinformationabouttheexactdimensions.

d.4Aboutoperationandcontrol.
Theairhandlingunitsmustbecompletedforfullyautomaticoperation.Controlmustbelimitedtochange
ofparametersviabuttonsanddisplayonahandterminal.Thealternativeisthatthecontrollerisconnected
toaBMSsystemwiththeabilitytoselectnewparametersviaPC,tabletorSmartphone.


d.5Warningsaboutdangers
PictogramsareaccordingtoEN1886about;







e.Drawings,diagrams,guidesandinstructionsfortheuse,maintenance
andrepair

AllDVunitswithintegratedcontrolsystemandTIMEunitsaremanufacturedincompliancewiththeEC
DeclarationofConformityandtheyareCEmarkedasmachines.UniqueDeclarationwithproduction
numberofthemachineisanintegralpartofthemachine–enclosedasannex1tothismanual.
Ifthe
buyercarriesoutchangesoraddscomponentsinoronthemachine,thebuyermustissueanewEC
DeclarationofConformityandanewCEmarkingofthemachine.Topromotecorrectuseofthemachines,
thebelow‐mentionedinstructionsareanintegralpartofthemachine:

Uniquedrawings,dataanddescriptionoffunctionsforthedeliveredunit–annex2
Disregardsofinstructionsshownon
warningsignsareconnectedbyrisk
forinjuryordamageonmaterial.
Warningaboutdangerbyrotating
parts
Warningaboutdangerbyelectricity
Warningaboutdangerbyheat