SystemAir DANVENT DV10 - Instructions Designed to Enable Adjustment and Maintenance to be Carried out Safely, Including the Protective Measures that Should be Taken During These Operations; S.1. Protective Measures and Additional Protective Measures; S.1.1 Necessary Protection Measures Prior to Start-Up; S.1.1.1 Design of Protection Measures


54

s.Instructionsdesignedtoenableadjustmentandmaintenancetobe
carriedoutsafely,includingtheprotectivemeasuresthatshouldbetaken
duringtheseoperations
s.1.Protectivemeasuresandadditionalprotectivemeasures
Adjustmentandmaintenancemustbedonebyskilledtechnicians–usuallybasedonservicecontractsfor
someyearsorlong‐termESCOcontracts.
Theunitsareprovidedwithguardstoavoidunintendedhazardsandinjurybecauseofrotatingpartsinthe
unit.Thepotentialsourcesofharmarethefanswith
fastrotatingimpellers.Hazardsfromtheimpellers
areobviousduringoperation,butwhenpoweriscut‐off,theimpellersarestillpotentialhazardsdueto
after‐runforatleast20seconds.Noticethatevencut‐offtheimpellersarestillpotentialhazards.
Thefanguard’saretheinspectiondoors
andthedoorsareprovidedwithlocks.Insidethedoorsare
additionalprotectioninstalled–guardsthatonlycanberemovedbyuseoftools.
Othermotor‐drivenpartsaredamperswithdampermotorsandrotaryheatexchangers,butthemovement
issoslowthatguardmeasuresarenotnecessary.Just
keepyourhandsawayfromplaceswithriskofinjury.
Useparticulaterespiratorwhenfiltersarereplaced.
s.1.1Necessaryprotectionmeasurespriortostart‐up. 
Ensurethatallprotectionmeasuresareinstalledcorrectbeforestart‐up.
s.1.1.1Designofprotectionmeasures
Insidethedoorsareadditionalprotectioninstalled–guards
thatonlycanberemovedbyuseoftools.
s.1.1.2Configurationoffrequencyconverters withinstalledguard
Afrequencyconverterismountedbesidethefaninsomeunits.Iftheconfigurationoffrequencyiscarried
outwiththefaninoperation,theguardmustbeinstalledforsafetyreasonsanda
longcablemustbe
installedbetweenthefrequencyconverterinsidetheunitandthecontrolpaneloutsidetheunit.
s.1.2Safeadjustmentandmaintenance
Beforemaintenanceandrepair,theunitmustbeswitchedoffbyswitchingofftheautomaticcircuit
breakersandblockthembypadlocks..Seetheillustrationbelow
abouthowtoplaceapadlockoneach
automaticcircuitbreaker.Notethatlampsmustbeswitchedonduringmaintenance(lampsarean
accessory–onlyinstalled,ifordered).
Usecut‐resistantglovesforprotectionagainstinjuryfromsharpmetalplateedges.UseCE‐markedgloves
forthispurpose.Use
helmetduringmaintenanceworkintheunit.

 

