SystemAir DANVENT DV10 - I.2.11 Refitting of Guards; I.3. Installation - Electrical; I.3.1 Necessary Overvoltage Protection Device, that Leads Lightning Overvoltage to an Earth Lead on a Safe Way; I.4 Installation - Pipes for Water

To Next Page

To Previous Page



29



i.2.11Refittingofguards

Theguardisasafetyguardinstalledinsidethedoor.Toolsarenecessaryfortheremovaloftheguard.Ifthe

guardhasbeendemountedduringtheinstallationonthesite,theguardmustberefittedbeforestartupof

theunit.



 



Inserttheedges

oftheguardintheframeprofileinthegroovethatisintheframeprofile,andconnect

bothpartsoftheguardatthemiddlewith2screws.

Replacethevibrationdampingfoamrubberlistifitisdamaged.

i.3.Installation‐electrical

i.3.1Necessaryovervoltageprotectiondevice,thatleadslightningovervoltagetoanearthleadonasafe

way.

TheInstallerandusermustbeawareofthefactthatlightningstrikesmakeariskthatrequiresinstallation

ofovervoltageprotectiondevicestoleadthelightningovervoltagetoanearthleadina

safeway.

Installerandusermusttakecareofthisaccordingtolocalstatutoryrequirements.

i.4Installation–Pipesforwater–hotandchilled,valvesanddrains

i.4.1Description

Iforderedwiththeunit,thevalvesandvalvemotorsarestoredinacartonboxplacedinsidetheunit.

Watertrap(s)–standardoroptional‐is(are)necessarytoensureescapeofwaterfromthetrayunder

plateheatexchangerand(or)coolingcoil.Watertrap(s)is(are)

storedinacartonboxplacedinsidethe

unit.



SystemAir DANVENT DV10 - I.2.11 Refitting of Guards; I.3. Installation - Electrical; I.3.1 Necessary Overvoltage Protection Device, that Leads Lightning Overvoltage to an Earth Lead on a Safe Way; I.4 Installation - Pipes for Water - Hot and Chilled, Valves and Drains