24
| Instructions for unloading on the site as well as installation and connection
After disposal of the transport brackets the yellow label on the outside of the fan inspection door has no function and
should be removed.
I.2.12 Refitting of guards
The guard is a safety guard installed inside the door. Tools are necessary for the removal of the guard. If the guard has
been demounted during the installation on the site, the guard must be refitted before startup of the unit.
Use an Allan key — size 6 or size 8 — for refitting the
safety guard. Replace the vibration damping rubber list if
it is damaged.
output |
To Next Page
Loading...
Need help?
General
