TAC I/NET 2000 - InetAMT.mdb File Conversion

To Next Page

To Previous Page

InetAMT.mdb File Conversion Utility I/NET Conversions

3-6 I/NET 2000 Getting Started

3. Select the Tenant range to be converted. For an initial

upgrade installation, you should convert all tenants (1

through 256).

4. Enter the

Directory where the files are stored, or use the

Browse button to locate the directory manually.

5. Select the

Version for the Target File. This is the version you

are upgrading to.

6. Ty pe in the

Directory where the converted files are stored, or

use the

Browse button to locate the directory manually. This

option allows you to specify a different directory for the

converted files, so that you may keep both versions.

Note: If you store the converted files in a different directory, make sure that

your I/NET 2000 system configuration gives the proper directory for

the converted files.

7. Click on the

Convert button to begin the conversion process.

The Conversion Details section of the display will show the

progress of the conversions.

8. When the conversion has finished running, click the

button to exit the program.

InetAMT.mdb File Conversion Utility

This utility converts the INETAMT database into the format

required by I/NET2000 version 2.0. There are no parameters for the

user to enter, since the INETAMT requires a specific database name

and location. Figure 3-5 on page 3-7 shows the dialog for this

utility.

1. Click on the

Convert button to start the conversion. If the

INETAMT database is already in the proper version, the

Convert button will be grayed-out and unavailable.

2. After the conversion has been performed, click on the

button to exit the program.