TAC I/NET 2000 - ODBC32 Administrator Setup Guide

To Next Page

To Previous Page

I/NET 2000 Getting Started A-1

ODBC32 Administrator Setup

The procedures in this appendix provide the instructions necessary

to manually configure the ODBC32 Administrator for use with

AMT, Exporter/Reporter, and the I/NET ODBC Driver.

Follow these procedures only if you deselected the ODBC compo-

nent during the I/NET 2000 installation.

Note: The I/NET ODBC Driver interfaces with I/NET’s access control files.

It is used by other applications that require access to these files.

By default, I/NET’s installation program installs and configures the

ODBC32 Administrator. For this reason, it is strongly recom-

mended that you accept the default installation components. If,

however, you elect not to install ODBC32 during the initial instal-

lation, and install it at a later time, you will have to use the

following procedures to manually configure the ODBC32 Admin-

istrator.

1. To install ODBC32 Administrator, follow the installation

procedure outlined in “The Setup Program” on page 2-1

until you reach Step 11. Choose the Custom option.

2. The Select Components screen allows you to select compo-

nents for installation. Scroll to the second half of the

Components list and select

ODBC32 Administrator, as

shown in Figure A-1.

3. If necessary, deactivate (#) all other components and click

Next.

4. Complete the Setup program. If you require instructions on

the remaining screens, refer to Step 13 on page 2-11.

After Setup is complete, you must manually configure the ODBC

components.