I/NET Conversions DCUxxxx.sav File Conversion Utility
I/NET 2000 Getting Started 3-7
DCUxxxx.sav File Conversion Utility
This utility is used to convert any controller save (.SAV) files you
may have from their existing versions to a version that is compat-
ible with I/NET2000 version 2.0.
This utility does not launch automatically during the installation
process. It is also not included in the I/NET2000 menu folder,
because it runs in DOS rather than Windows.
Running this utility is highly recommended, to make sure you do
not accidentally download a save file that is in the old format. If you
choose not to run this utility, you should re-save all controller files
after downloading the new .BIN files, to ensure that the save files
are in the proper format.
Note: The current version of this utility is 51. This version converts DCU
save files from I/NET 2000 version 1.x to I/NET 2000 version 2.0
only. If your DCU save files are from an older version of I/NET, this
utility will not convert the files properly. You may use the previous
Figure 3-5. InetAMT.mdb File Conversion Utility
To Next Page
Loading...