Taco® SKV
80 302-365, Effective: June 5, 2017
© 2017 Taco, Inc.
5.The Standby drive (Drive B) should display in
the upper right hand corner of the screen (Set-up
2).
6.If Drive B remains in Set-up 1 , check the fol-
lowing:
a.Check that wire connections comply with
Figure A-1.
b.Check that both Drives’ active set-ups are set to
“Multi Set-up” per Section A.2 ”Settings”.
7.To test alternation, Press [OK] and [Right Arrow] at
the same time.
8.Observe the two drives swap setups.
a.Drive A switches to Set-up 2 , becoming the
Standby Drive.
b.Drive B switches to Set-up 1 , becoming the
Lead Drive.
9.Repeate step 7 as desired.
10.The pumps are now ready for alternation.
To Next Page
Loading...
