99
MAINTENANCE
Daily Inspection (Every 10 Hours)
Inspecting the Water Separator
WARNING
Stop the engine and allow the machine
to cool down before performing
inspection and maintenance.
1. Open the engine hood.
2. Inspect the water separator (1).
If the red indicator ring (6) is sunk to the
bottom of the case (4), no water is mixed
in.
If the red indicator ring (6) is floating, there
is water up to the bottom of the ring. Drain
the water and clean.
Refer to page 109 “Cleaning the Water
Separator”.
Checking the Fuel Level
WARNING
¡¡
¡¡
¡ Do not smoke or permit open flames
while fueling or near fueling operations.
¡¡
¡¡
¡ Stop the engine in a well-ventilated
place when adding fuel.
¡¡
¡¡
¡ Clean up spilled fuel immediately.
¡¡
¡¡
¡ Do not fill the fuel tank to capacity.
Allow room for expansion.
¡¡
¡¡
¡ Tighten the fuel filler cap securely.
1. Check the fuel level using the sight gauge
(3).
2. If the level is low, add fuel from the fuel
port (1) while watching the sight gauge (3).
Refer to page 39 “Fuel Filler Cap”.
1
2
3
B5G008
To Next Page
Loading...
