Takeuchi TB108 User Manual

75
OPERATION
Parking the Machine
Parking
WARNING
¡¡
¡¡
¡ Park the machine on firm, level ground
and apply the parking device.
¡¡
¡¡
¡ Before leaving the operator’s seat,
raise the safety lock lever to engage
the lock and stop the engine. If any
controls should be touched
accidentally when the safety lock lever
is lowered, the machine will move
suddenly, and cause serious injury or
death.
1. Set the left and right travel levers to the
neutral position.
2. Return the throttle lever and idle the
engine at low speed.
3. Set the slew lock lever to the locked
position.
4. Lower the bucket and dozer blade to the
ground.
5. Raise the safety lock lever to engage the
lock.
6. Stop the engine and remove the key.
Refer to page 55 “Stopping the Engine”.
Inspection and Checks After
Stopping the Engine
1. Check for oil and water leakage and
inspect the working equipment, covers
and lower body. If any irregularities are
found, repair.
2. Fill the fuel tank.
Refer to page 99 “Checking the Fuel
Level”.
3. Remove any paper scraps or dirt from the
engine room.
4. Remove any mud from the lower body.
Locking
Be sure to lock the following places:
¡ Engine hood
E3A4901

Takeuchi TB108 Specifications

General

Max Reach	3, 480 mm
Width	980 mm
Max Reach at Ground Level	3, 480 mm
Transport Width	980 mm
Engine Power	8.1 kW (10.9 hp)
Engine Gross Power	8.1 kW (10.9 hp)