Takeuchi TB108 - Daily Inspection (Every 10 Hours)

97
MAINTENANCE
Daily Inspection (Every 10 Hours)
Inspecting and Replenishing the
Coolant
WARNING
Do not remove the radiator cap or drain
plugs when the coolant is hot. Stop the
engine, let the engine and radiator cool
and loosen the radiator cap or drain plugs
slowly.
Inspection
1. Open the engine hood.
2. Place a cloth over the radiator cap (1) and
loosen it gradually to release the internal
pressure before removing it.
3. Inspect the coolant level in the radiator.
• The coolant level must be 30 mm (1.2 in.)
above the top surface of the radiator core.
• If the coolant level is low, add coolant.
Perform the following inspections once every day before starting the engine the first time.
WARNING
¡¡
¡¡
¡ Before operating, perform the Daily inspections and make repairs immediately should
any irregularities be found.
¡¡
¡¡
¡ Be sure to secure the engine hood when opening it. Do not open the engine hood
on slopes or in strong wind.
Replenishing
1. Add coolant to a level of 30 mm (1.2 in.)
above the top surface of the radiator core.
2. Install the radiator cap (1).