44
CONTROLS
Throttle Lever
This controls the engine speed.
(A) .... Low idling
(B) .... Maximum speed
Operating Levers
WARNING
¡¡
¡¡
¡ Be careful to check which pattern of
lever control arrangement you are
operating with before beginning
operations.
¡¡
¡¡
¡ The explanations in this manual are for
the ISO pattern.
Use these levers to operate the boom, arm,
bucket and upperstructure (slew).
Refer to pages 56, 57 “Lever Pattern”.
Refer to page 64 “Operating the Working
Equipment”.
Blade Lever
Use this lever to operate the dozer blade and
switch the crawler width.
(A) .... Blade up/narrow crawler width
(B) .... Blade down/wide crawler width
To change the crawler width, press the
selector lever in before operating it.
Refer to page 60 “Changing the Crawler Width”.
Travel Levers
WARNING
Before operating the travel levers, check
to make sure that the dozer blade is to
the front of the operator’s seat. BE
AWARE that when the dozer blade is to
the rear of the operator’s seat, the travel
levers operate in the opposite direction
to when the dozer blade is in the front.
Use these levers to move forward and
backward and to change directions.
Refer to page 61 “Operating the Travel Levers”.
Levers and Pedals
A
B
B5B011
B5B013
A
B
B5B012
B5B015
To Next Page
Loading...
