Tally Dascom 1125+ - Online State

Tally Dascom 1145/1125+
20
4.4 Online State
Function
Name
Switch
Operation
LED
Function Description
Tear Off
{S1}
L2, L3 flash
This is valid for tractor mode only. It feeds the form
to the tear-off position. After tearing off the form,
printing starts on the next TOF by pressing any key
or receiving print data from the host.
LF
{S2}
-
Feeds one line with every press of S2
FF
[S2]
-
Pressing this key will feed paper one line forward.
By holding down this key, the printer will initially feed
a few lines, then perform a form feed (continuous
paper mode) or eject the form (single sheet mode).
Load/Eject
{S3}
-
● Load: Automatically loads the paper (according to
path selection) when no paper is on the platen.
● Eject: For rear tractor, it retracts the form from the
platen to allow users to install cut sheets. (NOTE:
Users have to toggle the path selection lever.) For
cut sheets, it ejects the form on the platen.
Online
{S4}
L4
Toggles between Online and Offline states.
Setup State
[S4]
L4
Hold the S4 key for 3 seconds. Toggles to 3s Setup
state. Indicated by flashing L4.
Clear Buffer
and Reset
[S4]+{S1}
--
● Clears the print buffer. Beeps once upon
completion.
● Pressing S1 longer initializes the printer to
default settings. Beeps 3 times upon completion.