Tally Dascom 1125+ - Interface Setup

Tally Dascom 1145/1125+
28
Paper Setup
Valid Settings
Function
FormLen
MicroAdj
-20 -19 -18 -17 -16 -
15 -14 -13 -12 -11 -10
-9 -8 -7 -6 -5 -4 -3 -2 -
1 0 +1 +2 +3 +4 +5
+6 +7 +8 +9 +10 +11
+12 +13 +14 +15 +16
+17 +18 +19 +20
Fine tunes the form-length by n/360" (0.07mm)
based on the default value. (Valid for single papers
and fanfolds.)
Bail mode
Invalid, Standard,
Special
The bail mode presses the paper against the print
platen during printing, but it is released for paper
loading.
Invalid: If you uninstall the lever or want to disable
the function, set this setting to “invalid”.
Standard: Release the lever for paper loading and
lower the lever to press the paper against the platen
during printing.
Special: When the paper is in tear-off position, after
the printer received printing data, the printer will
judge whether tear-off was implemented first. If tear-
off was implemented and printing position is in lever
area, then the printer will press the lever; If tear-off
was not implemented, the printer will not press the
lever.
Roll Paper
No, Yes
In friction mode, 【LF/FF】will not eject the paper
and feed to next page. (Assume roll paper)
5.3 Interface Setup
Interface setup
Valid Settings
Function
PnP
No, Yes
No: Disables plug and play for USB
Yes: Enables plug and play.
USB ID
No, Yes
No: Disables USB ID.
Yes: Enables USB ID