Tally Dascom 1125+ - Page 37

Tally Dascom 1145/1125+
22
Function
Name
Switch
Operation
LED
Function Description
Hex Dump
[S3]
-
Beeps once to indicate going into hex dump mode:
● Prints data from host in hexadecimal
representation.
● Pressing S4 suspends the printing.
● When the hex dump has finished, pressing S4
forces the printing of the last line of data, as any
line termination control code from host has no
function.
● Switch off the power to terminate the hex dump.
Menu Setup
/ EDS
[S1]
-
Allows for Main Menu setting changes. Please read
the instructions printed on how to change settings
when this mode is activated. (EDS: Electronic DIP
Switch)
Self Test /
Status Page
[S4]
-
Prints the printer settings and self-test pattern.
Firmware
Update
[S1]+[S2]+[S3]
+ [S4]
L3, L4
● Alternate flashing of L3 and L4 indicates ready
for firmware update from host.
● When new firmware is being received: L3 and L4
flash together, while L1 and L2 LEDs are
constantly on.
When downloading is completed, the carriage
returns to home position. Printer initializes normally.
Restore
Factory
Defaults
[S2] + [S4]
-
Restore all settings to factory defaults.
The carriage initializes and the printer beeps once
after restoration.
Customize
Form
[S3] + [S4]
To customize the margins and tear-off position,
please refer Chapter 6 for details.