Tally T2030 - Page 22

Parameter group Parameter Description
Format 8 Bit No 1 Stop*
7 Bit Even 2 Stop
Odd
Mark
Spc
The number of data bits, a parity bit and the number of stop
bits per data byte can be set.
The following settings are possible for the parity bit:
NO = Transmission without parity bit
EVEN = Checking for even parity
ODD = Checking for odd parity
MARK/ = Transmission of 1 (MARK) or 0 (SPACE) instead of
SPACE the parity bit
Protocol XON/XOFF*
ENQ/STX**
Robust XON/XOFF
ETX/ACK**
Selection of the protocol type.
** for the 24-needle version only
Interf. Dual*
Parallel
Serial
Selection of the interface.
In Dual mode the printer automatically changes between
the parallel and the serial interface (Shared mode).
CG-Tab Graphic*
DLL
Italic
Appears only if the Epson emulation has been
selected. Italic, graphics or DLL character sets can be
selected.
CharSet Standard
Extended*
Selects standard character set or extended character set.
1
4
Menu description table
1 - 15