LC printing Certain professional applications may require unusually large character
sizes. Therefore your printer has the possibility of scaling standard size
characters up to factor 99 by means of control sequences.
The Header sequence defines the parameters (e.g. height) once. This
definition remains until the printer is switched off.
The printable LCP* information is transmitted in an LCP “bracket” (SI).
Two character sets are available:
■ US ASCII and
■ German
The printout of LCP characters can be selected in all of the emulations.
Prerequisite: Printer must be in Barcode mode.
* Large Character Printing
2
4
LC printing
2 - 19
To Next Page
Loading...
