List of available
control codes
The IBM Proprinter X/XL and Epson FX850/1050 emulations only apply to the
9-needle printer version, whereas the IBM Proprinter X24/XL24 and Epson
LQ850+/1050+ emulations only apply to the 24-needle versions.
In the following table the available sequences in the various emulations are
marked with the symbol ✔. MTPL sequences can be used in any of the emula-
tion modes. For this reason they are marked with an asterisk (
*
) in these emu-
lations.
2
4
✔✔ ✔ ✔ ✔ <BEL> Acoustic alarm
✔✔ ✔ ✔ ✔ <BS> Backspace
✔✔ ✔ ✔ ✔ <CAN> Cancel
✔✔ ✔ ✔ ✔ <ESC>[<n><SP>r print the following 16 characters max. in
transparent mode (<n> = 1 - 16)
✔
*****
<ESC>[:y right justification and centering OFF
✔
*****
<ESC>[=z emphasized mode ON
✔
*****
<ESC>[>z emphasized mode ON
✔
*****
<ESC>[?1~ MTPL command set
✔
*****
<ESC>[?10~ end of command interpretations
✔
*****
<ESC>[?11~ start of Barcode interpretation
✔
*****
<ESC>[?3~ MTPL + IBM-Proprinter command set
✔
*****
<ESC>[?4~ MTPL + IBM-Proprinter-24 command set
✔
*****
<ESC>[?5~ MTPL + EPSON FX command set
✔
*****
<ESC>[?50h load character set with 256 characters
✔
*****
<ESC>[?50l load 2 character sets with 94 character
✔
*****
<ESC>[?51h Set "Proportional not in Draft“
✔
*****
<ESC>[?51l Reset "Proportional not in Draft“
✔
*****
<ESC>[?52h "Ignore print quality“ ON
✔
*****
<ESC>[?52l "Ignore print quality“ OFF
✔
*****
<ESC>[?6~ MTPL + EPSON LQ command set
✔
*****
<ESC>[?7h at lineoverflow CR + LF
✔
*****
<ESC>[?7l at lineoverflow data are lost
✔
*****
<ESC>[0;0r clear top and bottom margin
✔
*****
<ESC>[0;0s set left and right margin
✔
*****
<ESC>[0c request for printer identification
✔
*****
<ESC>[0g clear horizontal tab stop at current position
✔
*****
<ESC>[0m clear all selected fonts
✔
*****
<ESC>[0n device status report: "Ready, no malfunction“
✔
*****
<ESC>[0<n1>;<n2>{ cut sheet paper
IBM IBM Epson Epson IBM-
MTPL Propr. Propr. FX850 LQ850+ AGM Code Function
X/XL X24/XL24 FX1050 LQ1050+
List of available control codes
2 - 5
To Next Page
Loading...
