Tally T2030 - Page 39

✔✔✔<ESC>
*
<39><n1><n2> graphics 180 dpi
✔✔✔<ESC>
*
<40><n1><n2> graphics 360 dpi
Formula: n = length of graphics data
<n2> = INT (n/256)
<n1> = n MOD 256
✔
*****
<ESC>+F designate character set G3
✔ <ESC>+<n> set line feed to n/360 inch (<n>= 0 - 255)
✔✔✔✔ <ESC>-<1> underline mode ON
✔✔ <ESC>-1 underline mode ON
✔✔✔✔ <ESC>-<0> underline mode OFF
✔✔ <ESC>-0 underline mode OFF
✔✔ <ESC>/<m> select vertical tab channel (<m> = 0 - 3)
✔✔ <ESC>: set condensed print with 12 cpi
✔✔ <ESC>:<0><n><m> copy ROM CG
✔✔ <ESC>< set unidirectional printing for one line
✔✔ <ESC><DC2> reset condensed print
✔✔ <ESC><DC4> reset enlarged print mode
✔✔ <ESC><EM>0 deactivate sheet feeder operation
✔✔ <ESC><EM>1 magazine 1 (front)
✔✔ <ESC><EM>4 activate sheet feeder operation
✔✔ <ESC><EM>R eject paper
✔✔✔✔ <ESC><SI> set condensed print
✔✔✔✔ <ESC><SO> set enlarged print mode
✔✔ <ESC><SP><n> set character spacing (<n> = 0 - 127)
✔✔ <ESC>= set bit 8 = 0
✔✔ <ESC>=<C1><C2>... downloading fonts/characters
✔✔ <ESC>> set bit 8 = 0
✔✔ <ESC>?<s><n> reassign graphics mode
<s> = K, L, Y or Z
<n> = 0 - 4, 6, 32, 33, 38 - 40
✔✔ <ESC>@ printer initialization
✔
*****
<ESC>[?53h column 8+9 of the character table are printable characters
✔
*****
<ESC>[?53 l column 8+9 of the character table are printable characters
or ignored (dependent of emulation)
✔✔ <ESC>[@<n1><n2>... set double height
✔ <ESC>[\<n1><n2>... changes vertical basic graduations
✔ <ESC>[F sheet feeder
✔ <ESC>[g<n1><n2><0> graphics 60 dpi
✔ <ESC>[g<n1><n2><1> graphics 120 dpi
✔ <ESC>[g<n1><n2><11> graphics 180 dpi
IBM IBM Epson Epson IBM-
MTPL Propr. Propr. FX850 LQ850+ AGM Code Function
X/XL X24/XL24 FX1050 LQ1050+
List of available control codes
2 - 10