Tandy 1000 MS-DOS User Manual

Chapter 13/ The DEBUG Utility
Type one or more flag designations, in any order, with or with-
out intervening spaces. For example:
NV UP DI NG NZ AC PE NC - PLEICY [ENTER I
DEBUG makes the requested changes.
R AX I ENTER I
DEBUG displays the contents of the single register AX:
AX elEelel
to change the contents to OOFF, enter FF after the colon prompt.
SEARCH
S range list
Searches specified memory for a list of bytes.
Parameters
range is the start and end address in memory where search will
be conducted.
list are the byte values to find.
Notes
• The list can contain one or more bytes, each separated by a
space or comma. DEBUG displays
the starting address for
each match found.
r 1
I
r
~
I I
LJ
I 1
, I
I •
'--'
i j
l..-J
LJ
LJ
1- 1
!
L...J
i !
'---'
,
~ I
U
• If no addresses are displayed, the list was not found.
•
If you enter only an offset for the starting address of range, I i
the segment indicated by register DS is used. '---'
, i
LJ
286
i ,
~

Tandy 1000 MS-DOS Specifications

General

Brand	Tandy
Model	1000 MS-DOS
Category	Desktop
Language	English