Tannoy Qflex User Manual

CONTENTS
INTRODUCTION
UNPACKING
SOFTWARE INSTALLATION & SETUP
3.1 BeamEngine Programme
3.2 MatLab Runtime Library MCR
3.3 QFlex BeamEngine Application
3.4 Updates
3.5 Uninstalling
INSTALLING THE MATLAB RUNTIME LIBARARY
INSTALLING THE BEAMENGINE APPLICATION
USING BEAMENGINE
6.1 Menu
6.2 Laying Out Venue Planes
6.3 Optimize Results
6.4 Adding Additional Venue Items
6.5 Probes
6.6 Saving Steering File
6.7 Balloon Data
6.8 BeamEngine – Frequently asked Questions
6.9 Some Design Tips
INSTALLING VNET SOFTWARE (PODWARE)
1
2
3
4
5
6
7
USING VNET SOFTWARE (PODWARE)
8.1 Overview
8.2 Layout
8.3 Menus
8.4 Toolbar
8.5 Communications
8.6 Launching a Panel
8.7 Controlling Devices – a quick overview
8.8 Parameter Synchronisation
8.9 Progress Bar
8.8 Navigation
8.9 The Selected Device
8.10 Device Context Menu
8.11 Control Panels
8.12 Loading Steering Data
8.13 Monicons
8.14 Controls
8.15 Filter Response Panels
8.16 Off-Line Operation
8.17 Saving and Recalling Data
8.18 Loading Factory Settings
8.19 Cloning a Device
8.20 Operating Mode
8.21 Device Properties
8.22 Device Firmware
8.23 Keyboard shortcuts
8

Tannoy Qflex Specifications

General

Brand	Tannoy
Model	Qflex
Category	Speakers
Language	English