Car mount
20 English
Introduction
Once the car mount has been fixed in place you can insert the navigation
device into the adapter plate. The noses on the adapter plate must fit into the
corresponding holes of the navigation device (see figure, arrow 1). In order to
orientate the navigation device to the correct viewing angle, move the flexible
gooseneck of the car mount to the desired position.
To loosen the navigation device from the car mount, press on the latch on top
of the adapter plate and remove the device.
To remove the car mount from the windshield, rotate the lock again and then
pull from the latch located at the bottom of the suction pad (see figure,
arrow 2).
To Next Page
Loading...