33
Model C606 Important: To the Operator
120515
Shake Fill Level Adjustment
The portion control sensor located under the cup
holder can be adjusted to fill the cup to the desired
level. If the fill level is too low, or the cup is
overfilling, it may be necessary to adjust the sensor
position. (See Figure 22.)
Figure 22
Step 1
Using a crescent wrench, loosen the locking nut on
the screw adjuster below the sensor.
Step 2
Turn the adjustment screw clockwise to raise the fill
level, or counterclockwise to lower the fill level.
Step 3
Once the desired fill level is achieved, tighten the
locking nut.
VFD Screens
The vacuum fluorescent display (VFD) located in the
center of the control panel is normally blank during
the daily operation of the machine. The display is
activated when the CALIBRATE symbol
or the
Manager's Menu is selected. The display screen will
also alert the operator of specific faults detected by
the control.
Power Up
When the machine is powered, the control system
will initialize to perform a system check. There will
four types of data that the system will check when
the control is initializing: Lamp Test, Lockout Data,
Configuration Data, and System Data.
(See Figure 23.)
C602 / C606 UVC4
V01.01.000
lamp
test
Figure 23
Lamp Test: The control and software version is
displayed and all of the LED's on the display panel
are illuminated. (See Figure 24.)
Initializing.....
Figure 24
Following the lamp test, three separate screens will
appear during initialization.
Initializing....LockoutData
Initializing....ConfigData
Initializing....SystemData
If the syst em detects corrupt data during the
INITIALIZING, the following display will alert the
operator that the control settings have changed
(See Figure 25.)
SERVICE REQ'D
NVRAM FAULT
RESET TO DEFAULTS
< Press to clear
Figure 25
To Next Page
Loading...
