91
Model C606 Operating Procedures
050801
Remove the two small o-rings and one large o-ring
from the pump drive shaft.
Disassembly - Soft Serve Side
Note: Failure to remove the parts specified below
for brush cleaning and lubrication will result in
damage to the machine. These parts must be
removed every 14 days or the machine will lock out
and will not operate.
Step 1
Be sure the power switch is in the OFF position.
Step 2
Remove the handscrews, freezer door, beater,
scraper blades, and drive shaft with drive shaft seal
from the freezing cylinder.
Step 3
Remove the scraper blade clips from the scraper
blades.
Step 4
Remove the drive shaft seal from the drive shaft.
Step 5
From the soft serve pump cylinder, remove the
retaining pin, mix inlet adaptor, valve cap, pump
gasket, and the piston. Remove the o-ring from the
piston and valve cap.
Step 6
Remove the freezer door gasket, front bearing, pivot
pin, draw handle, and draw valve. Remove the three
o-rings from the draw valve.
Note: DO NOT attempt to remove the star
design from the door. The star design is part of
the door and is NOT a removable piece.
Figure 231
Step 7
Remove the pump drive shaft from the drive hub in
the rear wall of the mix hopper. (See Figure 232.)
Figure 232
Remove the two small o-rings and one large o-ring
from the pump drive shaft.
Step 8
Remove the front drip tray and splash shield.
Remove the ladles from the two cold topping
containers.
Step 9
Remove the long drip pan from the front panel. Take
it to the sink for cleaning. (See Figure 233.)
Figure 233
To Next Page
Loading...
