88
Model C606Operating Procedures
041008
Draining Product From The
Freezing Cylinder
To drain the product from the freezing cylinders on
both sides of the machine, the steps will be the
same. Therefore, first drain the product from the
shake side, then go back and duplicate these
procedures for the soft serve side.
Step 1
Place the heater topping switches in the OFF
position by touching the heater symbols
.The
symbols will not be illuminated when the heaters are
off.
Step 2
Cancel automatic operation by touching the AUTO
symbol
. (See Figure 224.)
Figure 224
Step 3
Shake Side Only: Remove the shake cup holder.
Set it aside for cleaning later with all parts.
Step 4
Remove the hopper cover and agitator. Take these
parts to the sink to wash, rinse and sanitize.
Step 5
With a pail beneath the door spout, touch the
WASH and PUMP symbols
and open the
draw valve. (Shake Side: Touch any flavor
selection symbol to open the draw valve.)
Drain the product from the freezing cylinder and the
mix hopper. (See Figure 225.)
Figure 225
Step 6
When the flow of product stops, touch the WASH
and PUMP symbols
, cancelling the WASH
and PUMP modes. The shake draw valve will
automatically close when the WASH operation is
cancelled.
Step 7
Remove the locking clip, mix feed tube, pump clip
and the assembled air/mix pump. Place the parts
into the parts tray.
Step 8
Shake Side Only: Remove the syrup lines from the
freezer door by raising the syrup valve retainers and
pulling the valves straight out of the door. Insert the
syrup hole plugs in the syrup ports. Lower the
retainer pins to secure the hole plugs in the door.
Step 9
Repeat steps 2 through 7 for the soft serve side of
the freezer.
To Next Page
Loading...
