Taylor C606 - Soft Serve Freezing Cylinder Assembly

56
Model C606Operating Procedures
040803
Step 16
Raise the locking collar of the spinner coupling and
insert the spinner shaft into the cavity of the coupling
until the locking collar can drop into the locked
position. (See Figure 117.)
Figure 117
Step 17
Snap the restrictor cap over the end of the door
spout and install the syrup valve retainer pins.
(See Figure 118.)
Figure 118
Freezing Cylinder Assembly - Soft
Serve Side
Make sure the power switch is in the OFF
position. Failure to follow this instruction may result
in severe personal injury from hazardous moving
parts.
With the parts tray available for the soft serve side:
Step 1
Before installing the soft serve beater drive shaft,
lubricate the groove on the beater drive shaft. Slide
the beater drive shaft boot seal over the small end of
the beater drive shaft and engage into the groove on
the shaft. Heavily lubricate the inside portion of the
boot seal and also lubricate the flat end of the boot
seal that comes in contact with the rear shell
bearing. Apply an even coat of lubricant to the shaft.
DO NOT lubricate the hex end. (See Figure 119.)
Figure 119
Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube HP).