Taylor C606 - Page 63

57
Model C606 Operating Procedures
150416
Note: To ensure the mix does not leak out of the
back of the freezing cylinder, the middle section of
the boot seal should be convex or extend out from
the seal. If the middle section of the boot seal is
concave or extending into the middle of the seal,
turn the seal inside out. (See Figure 120.)
Figure 120
Step 2
Insert the beater drive shaft through the rear shell
bearing in the freezing cylinder and engage the hex
end firmly into the drive coupling. (See Figure 121.)
Figure 121
USE EXTREME CAUTION when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
Step 3
Before installing the beater assembly, inspect the
scraper blades and clips.
Check the scraper blades for any signs of wear or
damage. If a scraper blade is nicked or worn,
replace both blades.
Check the scraper blade clips to make sure they are
not bent and the slot is even for the entire length of
the clip. Replace any damaged clips.
Figure 122
Step 4
If the blades and clips are in good condition, install
the scraper blade clips over the scraper blades.
Place the rear scraper blade over the rear holding
pin on the beater. (See Figure 123.)
Figure 123
Note: Soft serve side scraper blades should be
replaced every 3 months.
Note: The hole on the scraper blade must fit
securely over the pin to prevent costly damage.