EasyManuals Logo

Taylor C606 User Manual

Taylor C606
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Section 8 Troubleshooting Guide
99
Model C606
Troubleshooting Guide
PROBLEM SHAKE SIDE
PROBABLE CAUSE
SOFT SERVE SIDE
PROBABLE CAUSE
EITHER SIDE
PROBABLE CAUSE
REMEDY PAG E
REF.
1. Soft lock
message
appears on
display.
a. An equipment fault
has occurred.
a. Determine reason the
failure occurred. Correct
cause for failure, then
select HEAT symbol to
start a heat cycle or
WASH to disassemble
and brush clean the
machine.
36
b. More than 24 hours
since the last HEAT
cycle.
b. The freezer must go
through a HEAT cycle
every 24 hours. The
freezer must now be
disassembled and brush
cleaned or placed in a
heat cycle.
36
c. The power switch is
in the OFF position.
c. The power switch must be
in the ON position. The
freezer must now be
disassembled and brush
cleaned or placed in a
heat cycle.
36
d. The freezer is not in
the AUTO or
STANDBY mode
when the heat cycle
was programmed to
start.
d. The freezer must be in the
AUTO or STANDBY
mode. The freezer must
now be disassembled and
brush cleaned or placed in
a heat cycle.
36

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor C606 and is the answer not in the manual?

Taylor C606 Specifications

General IconGeneral
BrandTaylor
ModelC606
CategoryFreezer
LanguageEnglish

Related product manuals