Taylor C606 - Page 48

42
Model C606Important: To the Operator
120515
Once the appropriate month has been entered,
scroll to the appropriate week. Touch the
CALIBRATION symbol
to accept the selection.
(See Figure 61.)
DST START WEEK
FIRST SUNDAY
> SECOND SUNDAY
THIRD SUNDAY
Figure 61
Note: Scroll down to see selections “FOURTH
SUNDAY” and “LAST SUNDAY”.
Select the month that Daylight Saving Time will end.
Touch the CALIBRATION symbol
to accept the
selection. (See Figure 62.)
DST E ND MONTH
>NOV
DEC
JAN
Figure 62
Select the appropriate week that Daylight Saving
Time will end. Touch the CALIBRATION symbol
to accept the selection. (See Figure 63.)
DST END WEEK
> FIRST SUNDAY
SECOND SUNDAY
THIRD SUNDAY
Figure 63
Select the CALIBRATION symbol
to exit the
screen and return to the Menu.
The AUTO HEAT TIME screen allows the Manager
to set the time of day in which the heat treatment
cycle will start. (See Figure 64.)
AUTO HEAT TIME
00:00
Change
>Exit
Figure 64
Note: Do not advance the Auto Heat Time setting
except on the day the unit is brush cleaned.
Increasing the time between heat cycles will cause
the machine to soft lock if the start of the cycle does
not begin within 24 hours from the start of the
previous heat treatment cycle.
To set the AUTO HEAT TIME select the AUTO
symbol
to move the arrow to Change. Then
select the CALIBRATION symbol
. The screen
will display the time with the cursor under the hour
position. (See Figure 65.)
AUTO HEAT TIME
00
:00
Figure 65
Select the AUTO symbol
or the OPTIONAL
FLAVOR symbol
to increase or decrease the
hour to the desired setting. Then move the cursor to
the minutes position by selecting the CALIBRATION
symbol
. Adjust the setting for minutes, then
select the CALIBRATION symbol
to save the
setting and return to the AUTO HEAT TIME screen.
Select the CALIBRATION symbol
to exit the
screen and return to the Menu.