84
Model C606Operating Procedures
Step 3
Advance the brush completely through the discharge
tube and pull the brush from the bottom of the tube.
Step 4
Insert the black shielded brush into the top side of
the inlet valve. Scrub this area, specifically around
the steel ball. (See Figure 212.)
Figure 212
Step 5
Insert the black shielded brush into the top side of
the outlet valve. Scrub this area, specifically around
the steel ball. (See Figure 213.)
Figure 213
Step 6
Insert the black shielded brush, by the non-bristle
end, into the passageway between the inlet valve
and the outlet valve. (See Figure 214.)
Figure 214
Step 7
Move the brush back and forth to scrub this
passageway. Advance the brush completely, and
pull the brush out of the valve body.
(See Figure 215.)
Figure 215
To Next Page
Loading...
