24
Beater Door Assembly - Soft Serve Side (See Figure 14)
ITEM
PART NO. DESCRIPTION QTY. FUNCTION WARR.
CLASS
1 X56421-1 Handle A.-Draw 1 Operational component of the
draw valve assembly.
103
2 055989 Nut-Stud 4 Tightening mechanism to secure
freezer door to freezing cylinder.
103
3 X57332-SER Door A.-w/Baffle 1 Covers open end of freezing
cylinder and provides port for the
product to be dispensed.
103
4 048926 Gasket (Freezer Door) 1 Provides a seal between freezer
door and the freezing cylinder.
000
5 050346 Shoe-Front Helix-Rear 1 Supports the beater assembly. 000
6 050348 Bearing-Front 1 Allows beater assembly to turn
freely in hub of freezer door.
000
7 050347 Shoe-Front Helix- Front 1 Supports the beater assembly. 000
8 X46231 Beater Assembly 1 Blends air and mix inside the
freezing cylinder and provides
force to dispense product.
103
9 046235 Blade -Scraper 2 Scrapes frozen product off wall of
freezing cylinder.
000
10 046236 Clip-Scraper Blade 2 Strengthens scraper blades. 103
11 032564 Drive Shaft 1 Connects beater assy. to gear
unit.
103
12 032560 Seal-Drive Shaft 1 Provides seal from product inside
freezing cylinder to internal areas
of the freezer.
000
13 055819 Pin -Pivot 1 Pivoting point for the draw handle
to raise or lower the draw valve.
103
14 X55820 Valve A.-Draw 1 Seals o ff mix in freezer door
cavity. When raised, port opens
allowing product in freezing
cylinder to be dispensed.
103
15 014402 O-Ring (Draw Valve) 3 Provides a seal for draw valve in
freezer door cavity.
000
16 015872 O-Ring 1 Holds screw in set position. 000
17 056332 Screw-Adjustment 1 Adjustment for product draw rate. 103
Downloaded from www.dlmanuals.com
To Next Page
Loading...
