78
When one of these messages appears,
automatic freezer operation cannot take place
until the freezer is disassembled and brush
cleaned, or has comp leted a heat treatment
cycle. Select the HEAT symbol
to start a
heat cycle, or select the WASH symbol
to
disassemble and brush clean the machine.
Once the freezer is unlocked by starting a
heat treatment cycle the HEAT symbol
will
illuminate and the following message will be
displayed on the screen. (See Figure 174.)
L: DO NOT DRAW
R: DO NOT DRAW
Figure 174
If the WASH symbol is selecte d to clear the
lockout by brush cleaning the machine, the
FREEZER LOCKED message will remain on
the display until the brush clean requirements
are fulfilled. The freezer must be
disassembled in order to activate the five
minute timer on the display screen. Once the
timer counts down to zero, the lockout is
cleared. (See Figure 175.)
FREEZER LOCKED
Figure 175
To restore the message that identified the
reason for the soft lock, turn the power switch
OFF for five seconds, and then return the
power switch to the ON position. The original
message with the reason for the soft lock will
be displayed. (See Figure 176.)
HEAT TREAT FAILURE
REASON
HEAT FOR HEAT CYCLE
WASH TO BRUSH CLEAN
Figure 176
The FAULT DESCRIPTION can also be found
in the Manager’s Menu. (See page 83.)
Note: A record of Heat Cycle Data and Lock
Out History can be found in the Manager’s
Menu. (See page 85.)
MANAGER’S MENU
The Manager’s Menu is used to enter the
operator function displays. To access the
Menu, touch the center of the CONE symbol
on the control panel. (See Figure 177.)
Figure 177
The shake AUTO symbol , the OPTIONAL
FLAVOR symbol
and the CONE symbol
will be lit when the ACCESS CODE screen is
displayed.
In the Menu program, the shake side AUTO
symbol
, OPTIONAL FLAVOR symbol ,
and CALIBRATION symbol
will function as
menu keys.
AUTO (
) - increases the value above the
cursor and used to scroll upward in text
displays
OPTIONAL FLAVOR (
) - decreases the
value above the cursor and used to scroll
downward in text displays.
CALIBRATION (
) - advances the cursor
position to the right and is used to select menu
options.
Note: You will not be able to dispense shakes
while accessing the Manager’s Menu options,
except when the CURRENT CONDITIONS
screen is displayed.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
