79
The sundae side will continue operation in the
mode it was in when the Menu was selected.
However, the sundae side control keys will not
be lit and are non-functional when the
Manager’s Menu or Calibration Menu is
displayed.
The control keys for both sides are functional
in the Manager’s Menu when the CURRENT
CONDITIONS screen is displayed. (See
CURRENT CONDITIONS on page 87.)
Entering Access Code
With the ACCESS CODE screen on the
display use the AUTO (
)orOPTIONAL
FLAVOR (
) symbols to set the first code
number in the cursor position. When the
correct number is selected, touch the
CALIBRATION symbol
to move the cursor
to the next number position. (See Figure 178.)
ENTER ACCESS CODE
83 0 9
__
Figure 178
Continue to enter the proper access code
numbers until all four numbers are displayed,
then touch the CALIBRATION symbol
.The
Manager’s menu list will display on the screen
provided the correct access code is entered.
If an incorrect number is entered for the
access code, the display will exit the Menu
program when the CALIBRATION symbol
is selected. (See Figure 179.)
Figure 179
Menu Options
Touch the AUTO symbol
or OPTIONAL
FLAVOR symbol
to move up or down
through the Menu. Select a Menu option by
aligning the option with the arrow on the left
side of the screen, then touch the
CALIBRATION symbol
. Exit the Menu
program by selecting EXIT FROM MENU or
touch the CONE symbol
.
The following menu options are listed in the
Manager’s Menu.
EXIT FROM MENU
SYRUP CALIBRATION
VERIFY CALIBRATION
RESET DRAW COUNTER
SET CLOCK
AUTO HEAT TIME
AUTO START TIME
STANDBY MODE
BRUSH CLEAN CYCLE
MIX LEVEL AUDIBLE
FAULT DESCRIPTION
LOCKOUT HISTORY
HEAT CYCLE SUMMARY
HEAT CYCLE DATA
SYSTEM INFORMATION
CURRENT CONDITIONS
Selecting “EXIT FROM MENU” will exit the
Manager’s Menu and the return the control
panel symbols to normal operation.
The SYRUP CALIBRATION option allows the
manager to access the calibration screen
selections from the Manager’s Menu. The
same functions found in the calibration menu
are displayed on the screen when this menu
option is selected. (See “SYRUP SYSTEM” on
page 39.)
UNFLAVORED DRAW
SYRUP CALIBRATION
SYRUP PRIME
> EXIT
Note: The unflavored draw option will only
appear on the screen when the shake side is
in the AUTO mode.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
