50
SYRUP TOPPING PUMP
Syrup Topping Pump Disassembly
Before the first use, and after use weekly,
disassemble and clean the pump.
1. Flush and rinse the pump in a container of
warm water. Place the lower end of the
pump into the water container. Operate
the pump until only warm water flows from
the discharge tube.
2. Remove the pump from the container of
water for disassembly.
3. Remove the plunger assembly from the
pump body by turning the plunger nut
counterclockwise. (See Figure 67.)
Figure 67
4. To remove the knob, compress the spring
toward the knob, using the washer.
Compress it enough to grab onto the
plunger with your hand for support. Begin
removing the knob with your other hand.
Remo ve the knob o-ring. Remove the
plunger nut from the plunger tube.
(See Figure 68.)
Figure 68
5. Remove the plunger tube and the insert
from the plunger assembly. (See
Figure 69.)
Figure 69
6. Remove the spring and washer from the
plunger assembly. (See Figure 70.)
Figure 70
7. Remove the seal assembly from the
plunger assembly. (See Figure 71.)
Figure 71
Downloaded from www.dlmanuals.com
To Next Page
Loading...
