2
DO NOT operate the freezer unless all
service panels and access doors are
restrained with screws. Failure to follow this
instruction may result in severe personal injury
from hazardous moving parts.
DO NOT attempt to draw product or
disassemble the unit during the HEAT cycle.
The product is hot and under extreme
pressure.
DO NOT put objects or fingers in the
door spout. Failure to follow this instruction
may result in contaminated product or
personal injury from blade contact.
DO NOT remove the door, beater,
scraper blades, drive shaft or air/mix pump
unless all control switches are in the OFF
position. Failure to follow this instruction may
result in severe personal injury from
hazardous moving parts.
USE EXTREME CAUTION when
removing the beater assembly. The scraper
blades are very sharp and may cause injury.
This freezer must be placed on a level
surface. Failure to comply may result in
personal injury or equipment damage.
DO NOT install the unit in an area
where a water jet could be used, and do not
use a water jet to clean or rinse the freezer.
Failure to follow these instructions may result
in serious electrical shock.
This freezer is designed to operate indoors,
under normal ambient temperatures of
70° - 75°F (21° - 24°C). The freezer has
successfully performed in high ambient
temperatures of 104°F (40°C) at reduced
capacities.
DO NOT obstruct air intake and discharge
openings: 3” (76 mm) minimum air space all
sides. Install the deflector provided to prevent
recirculation of warm air. Failure to follow this
instruction may cause poor freezer
performance and damage to the machine.
NOTICE all warning labels that have been
attached to the freezer to further point out
safety precautions to the operator.
HAZARD COMMUNICATION STANDARD
(HCS) - The procedure(s) in this manual
include the use of chemical products.
These chemical products will be
highlighted with bold faced letters followed
by the abbreviation (HCS) in the text
portion of the procedure. See the Hazard
Communication Standard (HCS) manual for
the appropriate Material Safety Data
Sheet(s) (MSDS).
This piece of equipment is made in America
and has American sizes of hardware. All
metric conversions are approximate and vary
in size.
NOISE LEVEL: Airborne noise emission does
not exceed 78 dB(A) when measured at a
distance of 1.0 meter from the surface of the
machine and at a height of 1.6 meters from
the floor.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
Need help?
General
