58
10. Remove the pump drive shaft from the
drive hub in the rear wall of the mix
hopper. (See Figure 95.)
Figure 95
Remove the two small o-rings and one
large o-ring from the pump drive shaft.
Disassembly - Soft Serve Side
Note: Failure to remove the parts specified
below for b rush cleaning and lubrication will
result in damage to the machine. These parts
must be removed every 14 days or the
machine will lock out and will not operate.
1. Be sure the power switch is in the OFF
position.
2. Remove the handscrews, freezer door,
beater, scraper blades, and drive shaft
with drive shaft seal from the freezing
cylinder.
3. Remove the scraper blade clips fro m the
scraper blades.
4. Remove the drive shaft seal from the
drive shaft.
5. From the soft serve pump cylinder,
remove the retaining pin, mix inlet
adaptor, valve cap, pump gasket, and the
piston. Remove the o-ring from the piston
and valve cap.
6. Remove the freezer door gaske t, front
bearing, pivot pin, draw handle, and draw
valve. Remove the three o-rings from the
draw valve.
7. Remove the pump drive shaft from the
drive hub in the rear wall of the mix
hopper. (See Figure 96.)
Figure 96
Remove the two small o-rings and one
large o-ring from the pump drive shaft.
8. Remove the front drip tray and splash
shield. Remove the ladles from the two
cold topping containers.
9. Remove the long drip pan from the front
panel. Take it to the sink for cleaning.
(See Figure 97.)
10394
Figure 97
Downloaded from www.dlmanuals.com
To Next Page
Loading...
