69
7. Insert the valve cap into the hole in the
mix inlet adapter. (See Figure 139.)
15111
Figure 139
8. Insert the mix inlet assembly into the
pump cylinder. (See Figure 140.)
15112
Figure 140
The adapter must be positioned into the
notch located at the end of the pump
cylinder.
9. Secure the pump parts in position by
sliding the retaining pin through the cross
holes located at one end of the pump
cylinder. (See Figure 141.)
15113
Figure 141
Note: The head of the retaining pin
should be located at the top of the pump
when installed.
10. Assemble the feed tube assembly. Slide
the check ring into the groove of the feed
tube. (See Figure 142.)
15120
Figure 142
11. Install one red o -ring on each end of the
mix feed tube, and thoroughly lubricate.
(See Figure 143.)
15121
Figure 143
12. Lay the pump assembly, pump clip, cotter
pin and agitator in the bottom of the mix
hopper for sanitizing. (See Figure 144.)
Figure 144
Downloaded from www.dlmanuals.com
To Next Page
Loading...
