71
6. CAUTION!
Install the pump end of the mix feed
tube and secure with the cotter pin.
Failure to follow this instruction could
result in sanitizer spraying on the
operator.
7. Using the white hopper brush, clean the
mix level sensing probes, the mix hopper,
mix inlet hole, the outside of the agitator
drive shaft housing, the agitator, the
air/mix pump, pump clip, mix feed tube
and cotter pin.
8. Pour the four gallons (15.2 liters) of
sanitizing solution into the mix hopper.
The sanitizing solution should be within 1”
(2.5 cm.) of the top of the hopper.
9. Using the white hopper brush, scrub the
exposed sides of the hopper. Wait at least
five minutes before p roceeding with these
instructions.
10. Place the power switch in the ON position.
11. Touch the WASH symbol
. This will
cause the sanitizing solution in the
freezing cylinder to come in contact with
all areas of the freezing cylinder.
(See Figure 149.)
Figure 149
12. With a pail beneath the door spout, open
and close the draw valve six times.
13. Touch the PUMP symbol
to sanitize
the inside of the air/mix pump and the mix
feed tube.
14. Open the draw valve and draw off all the
rema ining sanitizing solution.
15. Touch the WASH and PUMP
symbols
to stop the WASH and
PUMP modes and to close the draw
valve. (See Figure 150.)
Figure 150
Note: Be sure your hands are clean and
sanitized before going on in these
instructions.
16. Place the agitator on the agitator drive
shaft housing. (See Figure 151.)
Figure 151
Note: If the agitator paddle should stop
turning during normal operation, with
sanitized hands, remove the agitator from the
agitator drive shaft housing and brush clean
with sanitizing solution. Install the agitator
back onto the agitator drive shaft housing.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
