73
5. Prepare another 2.5 gallons (9.5 liters) of
McD Sanitizer (HCS) solution. Use one
packet in 2.5 gallons (9.5 liters) of water
(100 PPM).
6. Pour the sanitizing solution into the mix
hopper.
7. Brush the exposed sides of the hopper.
Wait at least 5 minutes before proceeding
with these instructions.
8. Touch the WASH symbol
. This will
cause the sanitizing solution in the
freezing cylinder to be agitated.
9. With a pail beneath the door spout, open
the draw valve and touch the PUMP
symbol
. Open and close the draw
valve 6 times. Open the draw valve and
draw off the sanitizing solution.
10. Touch the WASH and PUMP symbols
and close the draw valve.
(See Figure 154.)
Figure 154
Note: Be sure your hands are clean and
sanitized before going on in these
instructions.
11. Place the agitator on the agitator drive
shaft housing. (See Figure 155.)
Figure 155
Note: If agitator should stop turning during
normal operation, with sanitized hands,
remove agitator from agitator drive shaft
housing and brush clean with sanitizing
solution. Install the agitator back onto the
agitator drive shaft housing.
12. Remove the cotter pin from the pump.
Stand the mix feed tube in the corner of
the mix hopper. Place the cotter pin in
position in the outlet fitting of the pump.
(See Figure 156.)
Figure 156
Note: You have just sanitized all food
contact surfaces of the freezer.
Downloaded from www.dlmanuals.com
To Next Page
Loading...
