Taylor PH71 - Manual Brush Cleaning

34
Models PH71/PH84Operating Procedures
Step 2
Return to the freezer with a small amount of sanitizing
solution. With a pail beneath the door , dip the end
brush into the sanitizing solution and brush clean the
door spout(s) and bottom of the draw valve(s).
Figure 47
Note: To assure sanitary conditions are maintained,
brush clean each item for a total of 60 seconds,
repeatedly dipping the brush in sanitizing solution.
Install the design cap(s) on the freezer door spout(s).
(See Figure 48.)
Figure 48
Rinse a single service towel in sanitizing solution, and
wipe down the freezer door and area around the
bottom of the freezer door . Install the front drip tray and
splash shield.
Step 3
When ready to resume normal operation, press the
AUTO key. (See Figure 49.)
Figure 49
Note: This procedure should be done 15 minutes
before product is expected to be served.
Manual Brush Cleaning
THIS PROCEDURE MUST BE DONE EVERY 14
DAYS!
ALWAYS FOLLOW LOCAL HEALTH CODES.
To disassemble your unit, the following items will be
needed:
S T wo cleaning pails
S Necessary brushes (provided with freezer)
S Cleaning solution
S Sanitizing solution
S Single service towels