9
Model R280
6. Take the removable components from the Dispenser
to the washing area. Wash them with a hot solution of
detergent and water. Rinse each component with
clear water and sanitize (wash/rinse/sanitize) (HCS).
Allow components to air-dry.
Note: The removable components are not
dishwasher safe.
7. Move the Dispenser out from the wall to clean behind
and underneath it.
CAUTION! DO NOT roll the Dispenser to the
back sink for cleaning. Failure to follow this instruction
will cause unnecessary wear on the Dispenser.
8. When the cabinet is free of frost, wipe down the
internal and external cabinet with a hot solution of
detergent and water. Rinse with clear water and
repeat wipe-down with sanitizing solution (HCS) and
allow to air-dry.
CAUTION! DO NOT spray the Dispenser with
liquid or solvents. The Dispenser does not provide a
watertight seal. Failure to follow this instruction may allow
contaminants and moisture may get into sensitive
components.
9. Dry all components and reassemble the Dispenser.
See
Dispenser Assembly on page 6. Move the
Dispenser back into place.
Important! The Dispenser must be accessible from
all sides for routine cleaning and maintenance. A
minimum of 0.5 in. (13 mm) clearance on both sides
and 2 in. (50 mm) behind the Dispenser is
recommended.
To Next Page
Loading...
Need help?
General
