21
Model R280
Error Detection
The main display and Basket Size button LED lights will flash with the detection of an error condition for the affected
side. The display will state the error that has occurred (e.g. “Err 4”).
If an error does occur, it is normally reset by pushing the Enter button. If the failure continues, turn the power
switch off and unplug the power cord from the wall outlet. Check the power cord for any obvious defect. Open the
cabinet door to make sure the Dispenser is loaded properly and is properly assembled (see Dispenser Assembly on
page 6).
See Troubleshooting on page 22 for troubleshooting an error condition.
Note: Errors 5, 6 and 7 are refrigeration errors. These errors, while requiring corrective action, will not disable the
fry dispensing portions of the equipment. In order to safeguard the refrigeration system, errors 6 and 7 will not reset by
pushing the Enter button. These errors are reset from the Diagnostic Menu using Diagnostic Function D08.
Contact a service technician for assistance with these errors.
Error Codes
Error Description
01 Timeout error on left accumulator.
02 Timeout error on right accumulator.
03 Left tare weight has shifted excessively.
04 Right tare weight has shifted excessively.
05 Refrigeration progress too slow. (>25°F for 1.75 Hr)
06 Refrigeration high-pressure switch has tripped.
07 Error on refrigeration relay drive.
08 Temperature probe input out of range.
09 Invalid data in configuration (normal first time).
10 Internal system error
To Next Page
Loading...
Need help?
General
