OPERATING PROCEDURES
6-7
Model C708 - WAWA
Operating Procedures
6
6. Insert the assembled piston and liquid valve body
into the pump cylinder and push upward. Align the
steel button at the base of the valve body with the
cut-out groove at the bottom of the pump cylinder.
(
See Figure 6-25.)
Figure 6-25
Note: The hole in the piston must be visible through the
drive hole in the pump cylinder.
7. Assemble the mix inlet tube assembly. Slide the
O-ring and the seal into the grooves on the fittings
and thoroughly lubricate these parts.
(See Figure 6-26.)
Figure 6-26
8. Put the rubber poppet into the small end of the
spring. Attach the spring and poppet to the end of the
pressure relief fitting. The spring and poppet must be
securely fastened and must not be allowed to float
freely. (
See Figure 6-27.)
Figure 6-27
Note: The rubber poppet and spring act as a pressure
relief valve to prevent a pressure buildup in the freezing
cylinder.
9. Insert the assembled mix inlet tube into the holes in
the base of the liquid valve body. (
See Figure 6-28.)
Figure 6-28
Apply the appropriate
Taylor approved food safe lubricant.
HP
To Next Page
Loading...
