TCM FB30-7 - Page 106

6. STEERING SYSTEM
- 94 -
Fig. 6.28
Fig. 6.29
Fig. 6.30
Fig. 6.31
⑤
Install a set plate jig (See Fig. 6.61) on the front
cover installing position.
Tightening torque: 44 N-m {4.5 kgf-m}
[32.5 lbf-ft]
⑥ Extend outward the caulked part of the lock nut.
⑦ Securely holding the worm shaft spline, remove
the lock nut.
⑧ Remove the thrust washer, needle bearing, and
thrust washer.