TDE MACNO DVS200 - Serial Link Commands

124  Chapter 7 - Parameters Description User Manual
Serial Link Commands
As reported at the chapter PARAMETERS section Commands, setting the P.000 =3 (SERIAL), the main commands are
selectable exclusively via serial line or fieldbus.
The parameters listed below, are all the commands available when this function is selected.
H.500 Hardware Reset
Hardware reset
H.501 Alarm Reset
Alarm reset
H.502 Coast to stop
Coast to stop
H.503 Stop with ramp
Ramp to stop
H.504 Clockwise Start
Clockwise Start
H.505 Anti-clockwise Start
Anti-clockwise Start
H.506 Clockwise Jog
Clockwise Jog
H.507 Anti-clockwise Jog
Anti-clockwise Jog
H.508 Clockwise Flying restart
Clockwise Flying restart
H.509 Anti-clockwise Flying restart
Anti-clockwise Flying restart
H.510 DC Brake
DCBrake
Code Name [Code] & Function. Default MIN MAX Unit Variation IPA
H.500 0 0 1 1029
H.501 0 0 1 1030
H.502 0 0 1 1031
H.503 0 0 1 1032
H.504 0 0 1 1033
H.505 0 0 1 1034
H.506 0 0 1 1035
H.507 0 0 1 1036
H.508 0 0 1 1037
H.509 0 0 1 1038
H.510 0 0 1 1039