User Manual Chapter 9 - Troubleshooting 131
Chapter 9 - Troubleshooting
9.1 Drive Alarm Condition
The drive keypad will show on the 2
nd
line of alphanumeric display a blinking message with code and name of the alarm
occurred.
9.2 Alarm Reset
The alarm reset operation can be executed following three possibilities:
- Alarm reset by keypad buttoms: pressing simultaneously Up and Down; the reset action will take effect when the
buttons when released.
Reset allowed only with drive disabled.
- Alarm reset by digital input: it can be performed through a programmable digital input as
[5] Alarm reset.
Reset allowed only with drive disabled.
. Alarm reset by Autoreset function: it allows an automatic reset of some drive alarms (see table 8.3.1), by the settings
of P. 3 8 0 , P.3 8 1 , P.3 8 2 and P. 3 8 3 parameters.
Autoreset allowed with drive enabled too.
The figure below shows how to reset an alarm by keypad bottoms.
9.3 List of Drive Alarm Events
Table 9.3.1 provides a description regulation alarm events occurred during a drive alarm situation.
To Next Page
Loading...