- 122 -
EO3-11070
MA-1650-4 SERIES
NOTES: 1. A maximum of 16 characters can be programmed as the message for each Item Code. Only
regular-sized characters are effective.
2. As shown in the table above, the Standard Program Message is prepared for each Item Code
(which is auto-set after a RAM Clear). Therefore, program only the message that needs to be
changed.
ex.) To program “BALANCE DUE” instead of the Standard
Program Message “TOTAL” for Item Code 3:
Mode Lock: SET, 17 [X]
3 [ST] (Item Code 3)
402 [#] 401 [#] 412 [#] 401 [#] 414 [#] 403 [#]
405 [#] [#] 404 [#] 505 [#] 405 [#] (Message: BALANCE DUE)
[ST] (to complete this item)
[AT/TL] (to complete this submode)
COMBINATION REPORT TABLE PROGRAMMING (Submode 19)
In this operation, a maximum of three sets of reports to be issued on the individual terminal may be programmed.
Thus, in report taking, those reports contained in one set will be outputted in a string by a simple key operation.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
19 [X] |Table No.| [ST] |Report Code| [#] [ST] [AT/TL]
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-14-1994 MON #1
P17
#003 BALANCE DUE
0045
3 to 24 (See the REPORT
CODE TABLE below), or
0 to delete the table.
1 to 3
Repeat for other tables.
➤
➤
➤
➤
➤
*
* (For sequentially programming
Table, the Table No. specifica-
tion can be skipped.)
......
➤
➤
Repeatable for max. five
different reports combination.
To Next Page
Loading...
